Richard Jonsson wrote: > "rmmod bcm43xx" when kde is running hangs rmmod and prevents a clean > shutdown. > I tried to find which program causes this while using bcm4301 driver, but so > far no luck. System shuts down fine if I don't try to rmmod first. rmmod > works fine from runlevel 3 aside from this message when inserting module > again: > "net eth1: device_rename: sysfs_create_symlink failed (-17)"
I just got one of these during bootup, which prevented bcm43xx from starting correctly. The logged sequence was: kernel: bcm43xx-phy1: Broadcom 4311 WLAN found kernel: ssb: Switching to IEEE 802.11 core, index 1 kernel: bcm43xx-phy1 debug: Found PHY: Analog 4, Type 2, Revision 8 kernel: bcm43xx-phy1 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2 kernel: bcm43xx-phy1 debug: Radio turned off kernel: wmaster0: Selected rate control algorithm 'simple' ifup: Service network not started and mode 'auto' -> skipping kernel: net eth1: device_rename: sysfs_create_symlink failed (-17) ifup: Network interface is managed from NetworkManager ifup: NetworkManager will be advised to set up eth1 ifup: but it cannot be assured from here. kernel: bcm43xx-phy1 debug: Adding Interface type 2 kernel: ssb: Switching to PCI-E core, index 3 kernel: ssb: Switching to IEEE 802.11 core, index 1 kernel: bcm43xx-phy1: bcm43xx: Microcode bcm43xx_microcode5.fw3.fw loaded The fix for this was to 'modprobe -r bcm43xx' followed by 'modprobe bcm43xx', which got everything started OK. Larry _______________________________________________ Bcm43xx-dev mailing list Bcm43xx-dev@lists.berlios.de https://lists.berlios.de/mailman/listinfo/bcm43xx-dev