On Friday 18 April 2008 04:10:37 kala mazoo wrote: > > Greets, > > Following up on this idea of substituting sprom images; > > > Oops, sorry, here is the attached SPROM file.> > > > >On Tue, Apr 15, 2008 at 11:39 PM, Stefanik Gábor > >wrote: > > > > Looks like this is an Asus-specific issue. Can you try flashing the > > attached SPROM file (with a modified MAC address, of course) into your card > > to see if it results in *any* transmission? (Back up your SPROM first!) This > > is from a non-Asus 4318/02, extracted from a working card. (I can't test it > > myself now, as I don't have a usable Linux system ATM.) > > > > > > Using that sprom dump which Stefanik provided, the card in question here > appears to be now working (although I've not yet tested it at any length) > > ----- > > b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02) > b43-phy0 debug: Chip initialized > b43-phy0 debug: 32-bit DMA initialized > Registered led device: b43-phy0:tx > Registered led device: b43-phy0:rx > b43-phy0 debug: Wireless interface started > HW CONFIG: channel=1 freq=2412 phymode=2 > b43-phy0 debug: Adding Interface type 2 > b43-phy0 debug: Using hardware based encryption for keyidx: 0, mac: > ff:ff:ff:ff:ff:ff > ADDRCONF(NETDEV_UP): wlan0: link is not ready > wlan0: Initial auth_alg=0 > wlan0: authenticate with AP 00:1e:2a:61:7d:2c > wlan0: RX authentication from 00:1e:2a:61:7d:2c (alg=0 transaction=2 status=0) > wlan0: authenticated > wlan0: associated with AP 00:1e:2a:61:7d:2c > wlan0: associated > phy0: Added STA 00:1e:2a:61:7d:2c > ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
That's interesting. I didn't expect this. -- Greetings Michael. _______________________________________________ Bcm43xx-dev mailing list [email protected] https://lists.berlios.de/mailman/listinfo/bcm43xx-dev
