Step 1.) I followed this post to build Poky for the BBB: https://gist.github.com/errordeveloper/4056193
Step 2.) I followed this to setup the SD card: https://pixhawk.ethz.ch/tutorials/omap/boot_from_sd_sdhc Step 3.) I followed this for deploying my artifacts (MLO, u-boot, uImage & file system) https://pixhawk.ethz.ch/tutorials/omap/copy_sd_card I have also tried to swap out Step 2 above for the mkcard.txt script found here: http://downloads.angstrom-distribution.org/demo/beaglebone/ In all cases, I attempt to boot the BBB and I do not get anything over the HDMI display and nothing hits my routers DHCP server to receive an IP address. I do not have an FTDI Cable but can buy one if that is the logical next step in debugging. Any advice? Without an FTDI Cable, is there anyway to watch the boot process? Is the new Boot partition necessary (uImage, u-boot, MLO) or can I simply deploy the file system to the SD card? Sorry for the Newbie question! ~ Sayguh -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
