Is it your Gerald, that is responsible of this code ?
Micka, On Wed, Oct 23, 2013 at 2:30 PM, Micka <[email protected]> wrote: > Seriously ? No one care ? who is in charge of this change ? Who should I > contact ? > > Micka, > > > On Tue, Oct 22, 2013 at 5:18 PM, Micka <[email protected]> wrote: > >> A correction to my mail, normally it should be 0x154, which was the case >> before : >> >> bone_lcd7_cape_keys_00A3_pins: pinmux_bone_lcd7_cape_keys_00A3_pins { >> pinctrl-single,pins = < >> 0x040 0x2f /* KEY_LEFT gpmc_a0.gpio1_16, INPUT | PULLDIS | MODE7 */ >> 0x044 0x2f /* KEY_RIGHT gpmc_a1.gpio1_17, INPUT | PULLDIS | MODE7 */ >> 0x04c 0x2f /* KEY_UP gpmc_a3.gpio1_19, INPUT | PULLDIS | MODE7 */ >> 0x198 0x2f /* KEY_DOWN mcasp0_axr0.gpio3_16, INPUT | PULLDIS | MODE7 */ >> *0x154 0x2f /* KEY_ENTER spi0_d0.gpio0_3, INPUT | PULLDIS | MODE7 */* >> >; >> }; >> >> >> >> >> On Tue, Oct 22, 2013 at 4:45 PM, Micka <[email protected]> wrote: >> >>> Hi, >>> >>> I wanted to signal an error ( or not, but I double checked ) : >>> >>> >>> The Key ENTER of the LCD7 cap Rev A3 is connected to the GPIO0_3 >>> => >>> https://github.com/CircuitCo/BeagleBone-LCD7-RevA3/blob/master/BeagleBone-LCD7-RevA3-schematic.pdf?raw=true >>> >>> But In the last updated version of the file BB-BONE-LCD7-01-00A3.dts , I >>> got : >>> >>> >>> >>> 0x040 0x2f /* KEY_LEFT gpmc_a0.gpio1_16, INPUT | PULLDIS | MODE7 */ >>> 0x044 0x2f /* KEY_RIGHT gpmc_a1.gpio1_17, INPUT | PULLDIS | MODE7 */ >>> 0x04c 0x2f /* KEY_UP gpmc_a3.gpio1_19, INPUT | PULLDIS | MODE7 */ >>> 0x198 0x2f /* KEY_DOWN mcasp0_axr0.gpio3_16, INPUT | PULLDIS | MODE7 */ >>> *0x070 0x2f /* KEY_ENTER gpmc_wait0.gpio0_3, INPUT | PULLDIS | MODE7 */* >>> >>> >>> >>> Which is normally 0x954 and not 0x070 ( 0x070 is for GPIO0_30 ) >>> >>> >>> So, am I right or wrong ? If I'm wrong, why in june, july, ... the >>> address of uart4_rx was 0x070, which is GPIO0_30 ? >>> >>> >>> >>> >>> >>> Micka, >>> >> >> > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/groups/opt_out.
