Yes. 1.3A is what I meant. So, 1.3A may still be pushing it. Gerald
On Fri, May 23, 2014 at 2:57 PM, John Syn <[email protected]> wrote: > > From: Gerald Coley <[email protected]> > Reply-To: <[email protected]> > Date: Friday, May 23, 2014 at 12:53 PM > To: "[email protected]" <[email protected]> > Subject: Re: [beagleboard] Supply required 5V/2A over micro USB > > 13000mA might be pushing it. > > You mean 1,300mA? > > http://www.ti.com/lit/ds/symlink/tps65217c.pdf > > Page 43 > > Regards, > John > > > Gerald > > > > On Fri, May 23, 2014 at 2:52 PM, Gerald Coley <[email protected]>wrote: > >> I think that is the 800mA setting in the PMIC over current circuitry. >> >> Gerald >> >> >> >> On Fri, May 23, 2014 at 2:32 PM, Robert Nelson >> <[email protected]>wrote: >> >>> On Fri, May 23, 2014 at 2:26 PM, Gerald Coley <[email protected]> >>> wrote: >>> > Yes, but understand, you will only get 500ma out of it before the PMIC >>> shuts >>> > down depending on where the SW is currently set.I actually do not know >>> on >>> > the new image. Best case it 800mA. >>> >>> I still have it do the "i2c mw 0x24 1 0x3e;" in u-boot during bootup.. >>> So whatever that sets up the PMIC for. >>> >>> Regards, >>> >>> -- >>> Robert Nelson >>> http://www.rcn-ee.com/ >>> >>> -- >>> For more options, visit http://beagleboard.org/discuss >>> --- >>> You received this message because you are subscribed to the Google >>> Groups "BeagleBoard" group. >>> To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> For more options, visit https://groups.google.com/d/optout. >>> >> >> > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > For more options, visit https://groups.google.com/d/optout. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
