Hi Robert, thanks for your comments. > Yes and No... It'll boot, but not everything will work, ... > I'm not that sure about that. I just tried this and the BBB doesn't boot afterwards. But maybe I did a bad mistake. Here my steps:
1.) Downloaded your DTB-rebuilder " git clone -b 3.14-ti https://github.com/RobertCNelson/dtb-rebuilder.git"; 2.) Uncommented line 53 (/* #include "am335x-bone-can1.dtsi" */) in file dtb-rebuilder/src/arm/am335x-boneblack.dts. 3.) make 4.) copied the am335x-boneblack.dtb file to /boot/dtbs/3.16.1-bone4/ 5.) Reboot. Without result. After running modprobe can; modprobe can-dev; modprobe can-raw there was no CAN interface when typing ifconfig -a 6.) So I checked the uEnv file in /boot dir. There was a line "#dtb=" 7.) Then I uncommented this line and used dtb=/boot/dtbs/3.16.1-bone4/am335x-boneblack.dtb 8.) After reboot all 4 LEDs stay lid and after lets say 30 seconds its seems that the board reboots again. What did I wrong here? Any ideas? In the meantime I will reflash my board and start again... :) Hope you can help me once again! Thanks a lot!!! -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
