On Tue, Nov 25, 2014 at 8:25 AM, Robert Nelson <[email protected]> wrote: > On Tue, Nov 25, 2014 at 8:14 AM, Marco Steger <[email protected]> wrote: >> >> Hi Robert, >> thanks for your comments. >>> >>> Yes and No... It'll boot, but not everything will work, ... >> >> I'm not that sure about that. I just tried this and the BBB doesn't boot >> afterwards. But maybe I did a bad mistake. Here my steps: >> >> 1.) Downloaded your DTB-rebuilder " >> >> git clone -b 3.14-ti https://github.com/RobertCNelson/dtb-rebuilder.git"; >> >> 2.) Uncommented line 53 (/* #include "am335x-bone-can1.dtsi" */) in file >> dtb-rebuilder/src/arm/am335x-boneblack.dts. >> 3.) make >> 4.) copied the am335x-boneblack.dtb file to /boot/dtbs/3.16.1-bone4/ >> 5.) Reboot. Without result. After running modprobe can; modprobe can-dev; >> modprobe can-raw there was no CAN interface when typing ifconfig -a > > Do you have can enabled? > > The can "pinmux" relies on this patchset in my v3.14.x tree: > > https://github.com/RobertCNelson/ti-linux-kernel-dev/tree/ti-linux-3.14.y/patches/beaglebone/pinmux-helper > >> 6.) So I checked the uEnv file in /boot dir. There was a line "#dtb=" >> 7.) Then I uncommented this line and used >> dtb=/boot/dtbs/3.16.1-bone4/am335x-boneblack.dtb > > Yuck, don't do that, just the file name.. (i need to add the exact > path to the lookup function in u-boot so user's don't break their boot > via ^^^^that^^^) > >> 8.) After reboot all 4 LEDs stay lid and after lets say 30 seconds its seems >> that the board reboots again. >> >> What did I wrong here? Any ideas? >> >> In the meantime I will reflash my board and start again... :)
btw, just to refresh everyone on all the branches. Right now i'm mainly focusing on the "v3.14-ti" branch, as a stepping stone off "v3.8.x" Otherwise, i'm staying in sync with mainline, as dt "overlay's" are getting so close: http://www.spinics.net/lists/devicetree/msg59480.html Regards, -- Robert Nelson http://www.rcn-ee.com/ -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
