Hello, I have a L298 Motor Driver. I was wondering a couple of things.
First: - Do I need only software to type up to interface w/ motor drivers? Second: - While interfacing w/ this driver, do I need to make a library? If you have time, please view these ideas if you are willing to relay info. back to me: - http://www.st.com/en/motor-drivers/l298.html - https://www.sparkfun.com/datasheets/Robotics/L298_H_Bridge.pdf Oh and please look over my specific motor driver and the schematic here: <https://lh3.googleusercontent.com/-rNBT-OyaXF8/WtfSOJngyRI/AAAAAAAAJ6A/xq8-9J8U71U4jZtrKo-6J3T8PRXq4PImgCLcBGAs/s1600/ForBBB.PNG> Hopefully...this is enough info. for you to relate to my dilemma. Seth P.S. If you get bored, please do not hesitate to contact me. Thank you to anyone for support. There is a eight pin jumper that I have had some trouble w/ so far. I am not sure where to put the jumper pins. -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/e103d21d-c258-4cb4-b2c3-3bbf0a739a4c%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
