Hello Sir, Seth here. Mr. Dennis, I was looking over the ideas and software. I really appreciate you taking time out to make me understand what exactly I was "achieving" w/ my software ex. and the setup. I am actually attached from P9_21 and P9_22 only now. I realized that I might have to add more leads to the L298 Board to make the motors turn.
I have taken away these leads to the L298 Board and now just using what I described. I see why you are right here. I have changed the software so many times, I forgot what exactly I was using. I am not using En A or En B for my board. I will now, though. I had the jumper pins over the En A and En B pins on the L298 Board. Seth P.S. You have given me more ideas so far. Thank you, sir. I see where the m1a and m1b was doubled, w/out my looking over it, and caused the pin to be executed twice w/ the latter being the one used. On Thursday, May 3, 2018 at 10:22:29 AM UTC-5, Dennis Lee Bieber wrote: > > On Thu, 03 May 2018 11:14:51 -0400, Dennis Lee Bieber > <[email protected] <javascript:>> declaimed the following: > > > > Your "final cleanup" will only be performed IF you hit <ctrl-c> > BEFORE > >the loops run out. Otherwise, you just fall off the end of the program > with > >no cleanup performed > > > > Whoops -- missed the "while True:" master loop... Ignore that > comment > > > > -- > Wulfraed Dennis Lee Bieber AF6VN > [email protected] <javascript:> > HTTP://wlfraed.home.netcom.com/ > > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/4e594d10-7762-4d05-9500-ed54d1d93107%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
