Hello Once More, I am reverting back to 4.4.x. I tried 4.9.x and 4.14.x but to no avail. I will keep plugging at it.
Seth On Wednesday, April 18, 2018 at 6:20:20 PM UTC-5, Mala Dies wrote: > > Hello, > > I have a L298 Motor Driver. I was wondering a couple of things. > > First: > > > - Do I need only software to type up to interface w/ motor drivers? > > Second: > > > - While interfacing w/ this driver, do I need to make a library? > > > If you have time, please view these ideas if you are willing to relay > info. back to me: > > > - http://www.st.com/en/motor-drivers/l298.html > - https://www.sparkfun.com/datasheets/Robotics/L298_H_Bridge.pdf > > > Oh and please look over my specific motor driver and the schematic here: > > > <https://lh3.googleusercontent.com/-rNBT-OyaXF8/WtfSOJngyRI/AAAAAAAAJ6A/xq8-9J8U71U4jZtrKo-6J3T8PRXq4PImgCLcBGAs/s1600/ForBBB.PNG> > > Hopefully...this is enough info. for you to relate to my dilemma. > > Seth > > P.S. If you get bored, please do not hesitate to contact me. Thank you to > anyone for support. There is a eight pin jumper that I have had some > trouble w/ so far. I am not sure where to put the jumper pins. > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/7d236d2b-6627-4dd8-b745-61fa61bbe0e2%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
