Uh, in the second example, that is not needed since it is already commented out and the Boot Button is used:
*##enable BBG: eMMC Flasher:* *#cmdline=init=/opt/scripts/tools/eMMC/init-eMMC-flasher-v3-bbgw.sh* If it were uncommented, then it would have to be commented out again before a boot. My end comment stated what was needed to use the flasher from the SD card instead of the Boot button. On Fri, Nov 1, 2019 at 9:51 AM Dennis Lee Bieber <[email protected]> wrote: > On Fri, 1 Nov 2019 09:07:22 -0700, in gmane.comp.hardware.beagleboard.user > jonnymo <[email protected]> wrote: > > > > > >After this, it should be a matter of just powering off the board and > >booting it again. > > > > Uh... Power-off, remove [flasher mode] SD card, then boot. > -- > Dennis L Bieber > > -- > For more options, visit http://beagleboard.org/discuss > --- > You received this message because you are subscribed to the Google Groups > "BeagleBoard" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/beagleboard/2iooredpie6l7cq6svqutqi1v2ep0bm37l%404ax.com > . > -- For more options, visit http://beagleboard.org/discuss --- You received this message because you are subscribed to the Google Groups "BeagleBoard" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/CAG99bkrSTWMHM-wgdYfkng6D7nre95P655qkn1%3D1nsD2Jg8eYw%40mail.gmail.com.
