On 12 Dec 2013, at 16:49, Lucas Garron wrote:
I used "Make Link In..." a lot while setting up my computer with a
fresh QS
install. I did this by typing "L" for the action.
However, typing "M" for action on a file actually defaults to "Make
Link
In..." now, instead of "Move To...". This happens even though "Move
To..."
is at rank 8, and "Make Link In..." at rank 335.
Yeah, the behavior works well in practice most of the time, but when it
doesn’t, the cause is not at all obvious. Here’s what’s going
on…
When the list of actions is populated, they’re ordered according to
how you arrange them in the preferences. But as soon as you type a
single letter, that all goes out the window and they’re sorted by rank
instead.
Technically, the order in the prefs *might* influence the ranking (not
sure), but not nearly as much as the number of times you’ve used an
action.
Looking through the Quicksilver preferences, I haven't found a place
where
this behaviour might be stored.
Look at `~/Library/Application Support/Quicksilver/Mnemonics.plist`
You’ll want to locate the actions under both “abbreviation” and
“implied”. They’re listed by identifier. You can either manually
adjust the numbers and abbreviations, or remove them to reset the
training.
--
Rob McBroom
http://www.skurfer.com/
--
You received this message because you are subscribed to the Google Groups
"Quicksilver" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/blacktree-quicksilver.
For more options, visit https://groups.google.com/groups/opt_out.
