Bob, That is interesting. I never found where compression fittings were all that difficult to work with, did you?
Al -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] Behalf Of Bob Kennedy Sent: Saturday, November 22, 2008 9:38 PM To: [email protected] Subject: Re: [BlindHandyMan] Shark Bights copper connectors I'm a big fan of compression fittings but they told me at Lowes and Home depot that they are selling less of them due to the new shark bites. Because they are tried and trusted I much prefer the compressions but everyone seems to want something that is easier to work with. ----- Original Message ----- From: Dale Leavens To: [email protected] Sent: Saturday, November 22, 2008 10:37 AM Subject: Re: [BlindHandyMan] Shark Bights copper connectors They are more expensive but if you want to be really secure I'd go with compression fittings. You can remove them should you need to and you can always buy replacement ferrules for pennies if damaged when removing or otherwise handling the fittings. They are fairly expensive but usually you don't use many. These days you can usually even buy fittings like shut-off valves and stop cocks which attach by compression fitting. They are very secure and really very forgiving. I haven't used the 'T' or elbow fittings but now I really like the stop cocks. ----- Original Message ----- From: Tom Hodges To: [email protected] Sent: Saturday, November 22, 2008 10:18 AM Subject: RE: [BlindHandyMan] Shark Bights copper connectors Bob, Thank you so much for the information. I will research this on the Internet to find out if they have other fittings, such as T's, elbows, etc. This could sure save me a lot of time and expense (not to mention headache) if they work well. Tom _____ From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Bob Kennedy Sent: Wednesday, November 19, 2008 10:07 PM To: [email protected] Subject: [BlindHandyMan] Shark Bights copper connectors I've used both the Shark Bights and the Gator bight or Gator grip, can't remember the right name for that one. One is from Lowes and the other from Home Depot. You do have to support them and I had the hardest time believing they would actually seal. But they do, and work great. All you do is take 2 ends of copper you want to join, clean the burs off, and slide them together. If you remember those Chinese handcuffs we all had as kids? Your fingers went in really easy but the harder you pulled to get them apart the more it bit into your fingers. Just slide the piece on 1 of the ends and then put the piece over the other pipe. Pull the pipes towards each other and your done. It takes a special tool to get them back apart. The tools come in a pack of 3 for about 2 dollars so you know it isn't much. It's a plastic piece cut to fit in the slot on the Shark Bight and you just pull it towards the pipe and it opens back up. Don't know if you can reuse it after taking it back apart. I was a chicken once it came back apart and just put on a new one. I can tell you it takes no special skills and compared to running a torch inside a wall, there is a lot less to worry about too. Both stores have them in the plumbing area and I'm not remembering the price right now. Seems to me it was between 3 and 4 dollars. Well worth it if you aren't comfortable soldering. [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed] [Non-text portions of this message have been removed]
