The only reason I can think there's a greater sign is because of quoting. As per my question, has anyone used a drill guide tool? Seems like the guide would be a useful thing too.
Noel On 6/23/09, Tom Hodges <[email protected]> wrote: > I cut a Vee into a piece of three quarter inch wood and hold my screw or > Drill bit into the Vee to hold it straight. > > > > From: [email protected] [mailto:[email protected]] > On Behalf Of Dan Rossi > Sent: Tuesday, June 23, 2009 11:44 AM > To: [email protected] > Subject: Re: [BlindHandyMan] screw driving and rilling straight > > > > > > > > > Noel, > > What I do when I am drilling, is I take a block that I know is nice and > square, actually, I use a 1 2 3 setup block. I stand that up next to the > spot where I want to drill, then just line up the drill bit with the edge > of the block. Once you get the drill going, you can slide the block out > of the way. Does a great job for me. > > -- > Blue skies. > Dan Rossi > Carnegie Mellon University. > E-Mail: [email protected] <mailto:dr25%40andrew.cmu.edu> > Tel: (412) 268-9081 > > > > > > [Non-text portions of this message have been removed] > >
