I'd prepare the card for upgrade again, then try again to run the upgrade
process. Dar and I upgraded without a hitch! I noticed the percentages
went down in my unit, up to seven percent before my unit did a reset and 7.2
came up. I also noticed didn't need the eboot.bin or eboot.zip files which
were once on my card. I'm pleased. It will probably take me a while to
figure out everything but the file manager seems to work very well!
Jim Aldrich
----- Original Message -----
From: "terry" <[EMAIL PROTECTED]>
To: "'Braillenote List'" <[email protected]>
Sent: Wednesday, September 06, 2006 5:24 PM
Subject: [Braillenote] Can't install 7.2
Ok folks and I know there are a lot on here who know more about this than
me. In any case..
1. prepared sd for installation.
2. installed successfully my key.
3. downloaded the proper bin file and loaded on sd card.
4. as per instructions pressed dots 4 and 5 along with reset.
5. tones started.
4. no matter what I do I always get an sd card error.
I do not believe that the sd card is in fact at fault. it worked fine to
install the key and when I did the prepare. I have used it for earlier
version upgrades as well and it is a dedicated card.
any insight would be most welcome.
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
___
To leave the BrailleNote list, send a blank message to
[EMAIL PROTECTED]
To view the list archives or change your preferences, visit
http://list.humanware.com/mailman/listinfo/braillenote
