Hello, Would the T type thermocouple work better than the K type? How does changing (increasing) the temp offset work out? I don't quite understand enough about that part. Do both controllers function, with the PID over riding the stock unit? Did you use a project box for the PID - I don't see a good way to attach to machine? My original temp controller is still kicking, but when it goes, I would probably upgrade to a PID. - Dennis > > I have converted my B2 using Fuji PX3 and K-type thermocouple a few > months back. > Thermocouple is inserted in the same well as the regular temp sensor. > PXR3 is signficantlly longer that Gicar controller, so I decided to > install it on the side of the machine > and keep the original one in place. In order to completely bypass > Gicar, its temperature offset has been significantly increased. The > parts ran me around 70$. > > Frankly, after this mod I have not noticed any significant change in > the cup compared to the rotary upgrade which was completed a month > ago. No more stale water in the tank, no annoying noise and you get > controlled pre-infusion and much better espresso. >
--~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Brewtus" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/brewtus?hl=en -~----------~----~----~----~------~----~------~--~---
