Hi Ira, The controller came from Furneco, which is the only source I knew of. I'm not sure which section of the instructions relates to this: 5. adjustment and configuration 5.1 set point temperature 5.2 parameters configuration, level 1 and level 2 parameters It's not requesting a password, and I didn't want to get in deeper than I needed to. I can include a pic of the instructions if that's helpful.
Ben On Monday, February 16, 2015 at 10:06:56 AM UTC-8, Ira wrote: > > Hello Benjamin, > > Monday, February 16, 2015, 9:54:09 AM, you wrote: > > > Just installed new steam pipe and new temperature controller. But with > the factory setting of zero, should the machine heat up? It heated up to > around 55 degrees, then I decided to set the brew temp to 93, at which > point it stopped heating up. So I turned the temp back down to zero, then > it continued to heat up until it exceeded 99 and displayed --. Now I can't > seem to get it to stop heating regardless of where the temp is set. Any > ideas? It would be a huge help if someone could call or email me about this. > > Where did the controller come from? If it is the generic one it usually > comes set for a refrigerator and you need to read the instructions and > change it over to heat. > > -- Ira > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
