Hi Ira, Thanks for the response! When you say to rebuild the grouphead, which parts exactly should I replace? The three valves alone are about $50, so I was hoping to pin point where the problem was specifically. I did read an old post about just replacing the seals so I'm curious whether I could just get away with that.
Thanks, Jesse On Sat, Sep 12, 2015 at 2:26 PM Ira <[email protected]> wrote: > Hello Jesse, > > > Saturday, September 12, 2015, 6:57:11 AM, you wrote: > > > I've noticed a little bit of water coming out of the bottom of the > grouphead (the long "tube" below) during a shot. See the picture attached > taken while backflushing. Not sure what that particular part of the > grouphead is called so I couldn't search for it here. > > > Rebuild the grouphead. You need one tool, the wrench to fit the big nut on > top so you don't scratch it, but other than that it's about 15 minutes and > not much money, Make sure you have some proper food safe grease, Dow 111 or > similar. > > > -- Ira > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
