To Ira's point, I'm pretty sure the seals are integral to the three parts; not sure they're removable. best, bmc Sent from my iPhone
> On Sep 12, 2015, at 13:15, Ira <[email protected]> wrote: > > Hello Jesse, > > Saturday, September 12, 2015, 12:27:11 PM, you wrote: > > > Thanks for the response! When you say to rebuild the grouphead, which parts > exactly should I replace? The three valves alone are about $50, so I was > hoping to pin point where the problem was specifically. I did read an old > post about just replacing the seals so I'm curious whether I could just get > away with that. > > > Remind me monday and I'll see what my cost for the parts is. I get wholesale > at the local espresso parts supplier and it's quite astonishing the markup > some of the internet places get. If it's 10 years old you should probably > replace everything but as I recall it's not that much money and it's > certainly not difficult. You just need wrenches for the big nut on top and > the big nut on the bottom. Tape before wrench helps prevent scratches. > Luckily, I already owned the proper tools. > > -- Ira > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at http://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
