By "the board" I assume you mean the Giemme, yes? Or the PID or digital thermostat, whichever it has? Either way, to my thinking, if you have power into the Giemme, and no power out, that seems like the source of the issue. Are you sure you're measuring the right wire/terminal on the p-stat, i.e. the input side and not the output side? (I only ask because....ahem....I've *heard* of people making this mistake....of course it wasn't me...). Also, are you checking the p-stat on the output side, thinking the p-stat is good, I.e. could it be bad and therefore only input voltage tells you anything?
Are the wires to the correct terminals on the Giemme? The replacement is slightly different than the original, and the numbers do not all match up the same as the old one. There is a diagram if you need it. If that's all fine, perhaps ask WLL if there's a warranty on the Giemme board--I recently found a guy here in WA that rebuilds them, but it's as expensive as getting a new one (about $75). Pretty unusual for one to fail that fast. Keep us posted. Best, bmc Sent from my apple IIe > On May 18, 2016, at 05:09, Eric S <[email protected]> wrote: > > A little more info- > > It does have power going in to the control board. When I turned it on, it > filled the boilers. Took almost the whole reservoir, so assume they are > both full. Then after the pump kicked off it didn't switch over to heating. > > >> On Tuesday, May 17, 2016 at 4:02:01 PM UTC-5, Eric S wrote: >> working on getting this new to me brewtus going. >> >> I am working my way through the WLL video about checking electronic systems, >> and I am not getting power to the pressure stat. >> >> Is it likely the whole board, or is there something else I can check in >> there. The board on this machine was replaced back in November or so. >> >> Thanks > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at https://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
