So, I just finished doing a rotary conversion on my old BIII and I think I'm close. I have two problems now.
1. I left a 2" spring out of the pump assembly. You know, how you finish the job and then you look around and see one extra part? So I can put it in, except I don't remember whether it goes in the inlet or outlet. I'm guessing outlet. Pressure seems fine without it, but I'm sure I'll need it eventually. 2. Since putting the machine back together the brew boiler doesn't heat up. Using an ohmmeter, there seems to be an open connection on the limit switch. I've had to reset it a couple of times before, but this time it doesn't click, just kind of squishes around, and doesn't seem to reset. Do I just need a new one? How dangerous is it to short out the limit switch temporarily, just to see if that is the problem. thanks, ~Bill -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
