Hi All, Have a Brewtus III with rotary pump for about 10 years. Only issues have been cracked copper fitting, replaced vacuum relief valve, and replaced a failed pressurestat.
Over the past few months, the PID would flicker and show '104' (firmware?) on screen while flashing but still able to pull shots and steam. Yesterday the PID was flashing very rapidly (maybe 3-5x per second) and when I went to pull a shot the water was room temperature. Steam/water dispenser were fine. I don't have electrical testing equipment but followed the WLL troubleshooting video, checked for loose wires and noticed the light on the SSR is NOT illuminated. Now when I turn the machine off and then back on, there is no PID reading for several minutes until the steam boiler gets warm, then the PID starts to light up (still flickering). The brew boiler is still not heating, and dispenses room temperature water even after several hours of being on. Any thoughts? Bad PID? SSR? Thanks for all your help! -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
