The steam boiler started filling again the day after I ordered the part and has been working fine for the last 3 weeks. If it stop again, I'll try the new probe. If the boiler fills with the wire disconnected I think it's the likely culprit. Good luck!
On Fri, Nov 24, 2017 at 1:53 PM, Do Kooijman <[email protected]> wrote: > Hi, I'm curious if you have solved the problem. My expobar Office leva PID > has the same problem. > > > > Op zaterdag 4 november 2017 21:08:02 UTC+1 schreef BklynJim: > > Hey guys. Put in the new board and the steam boiler still doesn't fill. > It does however, now fill if I remove the wire to the fill valve. Ordered > a new level probe from WLL. Hope that does the trick. > > This is the part. LEVEL PROBE 1/4 BRASS 60100040 > > > > On Saturday, October 28, 2017 at 12:00:09 PM UTC-4, BklynJim wrote:My > steam boiler fills when the machine is cold but won't refill once warm. I > took the wire off the water level sensor and it still doesn't fill. Any > ideas for what to check? > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at https://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. > -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
