Samuel, I have installed as per your suggestion, but sadly, got no result: When I type lsusb, I get a bus number and a device number, which shows that my prolific adaptor is on bus 1 device 006. I then type: Brltty -pm /dev/ttyUSB6 This comes up saying excess argument then gives the version number of brltty. Nothing on the display though.
Many thanks, David. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Samuel Thibault Sent: 18 June 2011 00:05 To: Informal discussion between users and developers of BRLTTY. Subject: Re: [BRLTTY] brltty - I'm confused! David Reynolds, le Fri 17 Jun 2011 23:54:50 +0100, a écrit : > I'm wondering whether as orca uses brlapi whether in fact it uses some > other configuration file to determine which default settings to set. The braille settings are in orca's preferences. > In the orca preferences, there is a Braille > section, which on my current installation the enable Braille is checked, but > there is no way to determine which Braille display is used. It's the display of the currently-running brltty. Samuel _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty _______________________________________________ This message was sent via the BRLTTY mailing list. To post a message, send an e-mail to: [email protected] For general information, go to: http://mielke.cc/mailman/listinfo/brltty
