I have a heavy duty portable drill, and center punching. We can do it here in
my garage in Meyerland.
Helping out a fellow BVARC member tomorrow morning at 1100, but home after 1300
hours tomorrow afternoon.
Rod MartinezKC5MZK832-423-5640
On Monday, May 1, 2017 5:54 PM, Gary Sitton via BVARC <[email protected]>
wrote:
Anyone know of anyone with the skills and tools to bore out four 1/2" holes
in an aluminum plate to 3/4". I'm very willing to pay. I considered a
step-bit or a straight drill but either is tricky, etc. This is for a base
plate on an antenna mast. The material is 6061-T6.
Gary, K5AMH
Sent with AquaMail for Android
http://www.aqua-mail.com
_______________________________________________
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Message delivered to [email protected]
_______________________________________________
BVARC mailing list
[email protected]
http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org
Message delivered to [email protected]
