Ok I'm an idiot. You want to enlarge the holes. Sorry. Misunderstood. Never mind my offer. Again sorry!
Sent from my i-Thingamajig > On May 1, 2017, at 6:16 PM, rodney martinez via BVARC <[email protected]> wrote: > > My bad....center punching is not necessary with a HALF INCH existing hole. > Didnt read the minor details in the request. Anyway, call me and we can do > it here. I have a 24 volt monster drill here. You hold one side, and I will > hold the other. > > Rod > > > On Monday, May 1, 2017 6:08 PM, rodney martinez via BVARC <[email protected]> > wrote: > > > I have a heavy duty portable drill, and center punching. We can do it here > in my garage in Meyerland. > > Helping out a fellow BVARC member tomorrow morning at 1100, but home after > 1300 hours tomorrow afternoon. > > Rod Martinez > KC5MZK > 832-423-5640 > > > On Monday, May 1, 2017 5:54 PM, Gary Sitton via BVARC <[email protected]> wrote: > > > Anyone know of anyone with the skills and tools to bore out four 1/2" holes > in an aluminum plate to 3/4". I'm very willing to pay. I considered a > step-bit or a straight drill but either is tricky, etc. This is for a base > plate on an antenna mast. The material is 6061-T6. > > Gary, K5AMH > > Sent with AquaMail for Android > http://www.aqua-mail.com > > > > _______________________________________________ > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Message delivered to [email protected] > > > _______________________________________________ > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Message delivered to [email protected] > > > _______________________________________________ > BVARC mailing list > [email protected] > http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org > Message delivered to [email protected]
_______________________________________________ BVARC mailing list [email protected] http://mail.bvarc.org/mailman/listinfo/bvarc_bvarc.org Message delivered to [email protected]
