--- In [EMAIL PROTECTED], "josef wagner" <josef- [EMAIL PROTECTED]> wrote: > good morning dave > i am afraid these motors are in the power range of 10 to 15 Watt only. > and for the three axis control you need at least 80 to 100 watt if you are > going to use a mill tool of say 5 mm diameter. > some years ago i have got two of such HP motors from a plotter > and used them in gauge I railway models for single axle drive - was > jsut sufficient, the motor size was 42 mm diamter and 75 mm length without > decoder > best regards from vienna > josef wagner > +++ >
My current project is a small PCB drilling machine. I am not looking for real power and these would seem to be around teh power of a NEMA23 triple stack or NMEA34 single stack stepper ? I'm assuimg 10- 15 watts would compare. But, the big question is how to drive them cheaply ! Has anybody hacked the driver board and controlled it directly ? I never thought about the output of a CAD program like HPGL as a driver software. Also, since it has a pen up/down signal it may be possible to convert that to a self contained peck driller driver. I could not find any manufactures markings so am not sure if they are Hathaway. Dave Addresses: FAQ: http://www.ktmarketing.com/faq.html FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/ Post Messages: [EMAIL PROTECTED] Subscribe: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] List owner: [EMAIL PROTECTED], [EMAIL PROTECTED], [EMAIL PROTECTED] Moderator: [EMAIL PROTECTED] [EMAIL PROTECTED] [EMAIL PROTECTED] [Moderators] URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO OFF Topic POSTS: General Machining If you wish to post on unlimited OT subjects goto: aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if you have trouble. http://www.metalworking.com/news_servers.html http://groups.yahoo.com/group/jobshophomeshop I consider this to be a sister site to the CCED group, as many of the same members are there, for OT subjects, that are not allowed on the CCED list. NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........ bill List Mom List Owner Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
