[casper] ZDOK+ Layout?

[Daniel S. Klopp]

I am designing a board with a ZDOK+ connector to interface with an 
IBOB.  According to the wiki http://casper.berkeley.edu/wiki/IBOB , it 
uses a Tyco ZDOK+ 40 differential pair connector and provides a link to 
the website.  Using the datasheet I was under the impression I would use 
1367130-1 layout with 40 pairs.  But when I measured the dimensions of 
the physical board and looked at the pin layout of another connector we 
have in the lab, it looks as if the correct layout to use is actually 
1367555. 
http://www.tycoelectronics.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Customer+Drawing%7F1367555%7FB%7Fpdf%7FEnglish%7FENG_CD_1367555_B.pdf%7FN-A 
.  However, that drawing has me a bit nervous as it is a customer 
provided document and not an official Tyco document.

Could someone please confirm the EXACT connector layout I should use?
Thank you,
-Dan


--
:(){ :|: & };: