Re: [casper] CASPER ISE 14.5 tool chain configuration problem

[Nie Jun]

Hi Wesley,

Our environment is:
CentOS 6.2 x64
ISE 14.5
Matlab R2012b

I followed the instructions on page you mentioned. Thanks!

Cheers,
Jun

On 14/01/14 15:20, Wesley New wrote:

Thanks Nie,

Ill add this to the https://casper.berkeley.edu/wiki/MSSGE_Setup_with_Xilinx_14_and_Matlab_2012b page

What OS are you using?

Wesley New
South African SKA Project
+2721 506 7365
www.ska.ac.za <http://www.ska.ac.za>

On Tue, Jan 14, 2014 at 4:57 AM, Nie Jun <nie...@xao.ac.cn <mailto:nie...@xao.ac.cn>> wrote:

    Hi guys,

    I encountered some problems while updating our development tool
    chain to 14.5.

    1. I couldn't use FFT blocks, it would give out lots of errors
    like "Initialization commands cannot be evaluated".

    2. The simulink displayed "No blocks" instead of the "CASPER DSP
    blockset" blocks.

    I searched in the mailing list and found one useful post
    <http://www.mail-archive.com/casper@lists.berkeley.edu/msg02970.html>
    from Mark Wagner. Finally I solved these two problems by giving
    all users the write privilege on the CASPER library directories.

    Just post in the mailing list in case of someone running into the
    same problems. Thanks!

    Cheers,
    Jun