Hi Amit Your Skarab would have been shipped with a firmware that supports DHCP on all GbE interfaces and bootloading over 1GbE (only). It includes support for the ADC mezzanine. You will probably need to use the Peralex BSP tools to access and boot the Skarab over 1GbE, rather than the CASPER toolflow.
If you would like to work with the CASPER tools, then you will need to overwrite the Peralex boot image with the CASPER boot image. This will provide additional support for booting the Skarab over 40GbE, but you will loose support for the ADC. The ADC firmware is currently provided as HDL code only-it has yet to be ported into a CASPER yellow block. I will pop by the office tomorrow to provide you with a link where you can download the Peralex BSP. Kind regards, Clifford On 20 Dec 2017 6:05 PM, "Amit Bansod" <[email protected]> wrote: > Dear All, > > I am trying to boot SKARAB and the it gets stuck at "ARP ENTRY ID:0 > IP:....". Is there any way to force a static ip address or boot via 1GbE > interface as well ? > > Many Thanks! > > Regards, > Amit > > -- > You received this message because you are subscribed to the Google Groups " > [email protected]" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].
