Hi Amit, There is currently not firmware that supports static IP, this could be changed with a few small modifications to the microblaze code and a recompile of the microblaze, but I would recommend using DHCP where at all possible. It should be an easy process to setup a DHCP server on your laptop or the server that the SKARAB connects to.
Once you have an IP address you will want to change the firmware to the latest CASPER firmware which will allow your board to be programmed over the 40gbe as well as provide range of other features. This can be done using the software Peralex supplied with the board or you can use our linux port of that (Mail me and Ill give you access to the github repository) The latest firmware bit streams can be found at https://github.com/ska-sa/skarab_bsp_images. Please give the wikipage a read https://github.com/casper-astro/casper-hardware/wiki/SKARAB#Board_Support_Package And as always, drop us a mail on the mailing list if you need any support. Regards Wes Wesley New South African SKA Project +2721 506 7300 www.ska.ac.za On Wed, Dec 20, 2017 at 8:15 PM, Clifford van Dyk <[email protected]> wrote: > Hi Amit > > Your Skarab would have been shipped with a firmware that supports DHCP on > all GbE interfaces and bootloading over 1GbE (only). It includes support > for the ADC mezzanine. You will probably need to use the Peralex BSP tools > to access and boot the Skarab over 1GbE, rather than the CASPER toolflow. > > If you would like to work with the CASPER tools, then you will need to > overwrite the Peralex boot image with the CASPER boot image. This will > provide additional support for booting the Skarab over 40GbE, but you will > loose support for the ADC. The ADC firmware is currently provided as HDL > code only-it has yet to be ported into a CASPER yellow block. > > I will pop by the office tomorrow to provide you with a link where you can > download the Peralex BSP. > > Kind regards, > Clifford > > On 20 Dec 2017 6:05 PM, "Amit Bansod" <[email protected]> wrote: > >> Dear All, >> >> I am trying to boot SKARAB and the it gets stuck at "ARP ENTRY ID:0 >> IP:....". Is there any way to force a static ip address or boot via 1GbE >> interface as well ? >> >> Many Thanks! >> >> Regards, >> Amit >> >> -- >> You received this message because you are subscribed to the Google Groups >> "[email protected]" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected]. >> To post to this group, send email to [email protected]. >> > -- > You received this message because you are subscribed to the Google Groups " > [email protected]" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > -- You received this message because you are subscribed to the Google Groups "[email protected]" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected].
