Wood screws, the screws on the port side are very long, going through a four loop handrail inside the cabin to the handrail outside. I have a dinette model with the galley portside, forward at the bulkhead.
"Phil Agur" <[EMAIL PROTECTED]> Sent by: [email protected] 06/12/2007 01:24 PM Please respond to [email protected] To <[email protected]> cc Subject RE: catalina27-talk: Woodworking question James, Do you have machine screws and barrel nuts or wood screws holding on the grab rails? Phil Agur s/v Wing Tip Secretary/Treasurer Call Sign WCW3485 IC27/270A MMSI 366901790 www.catalina27.org Vessel Doc# 1039809 -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Sneddon, Keith Sent: Tuesday, June 12, 2007 11:54 AM To: [email protected] Subject: RE: catalina27-talk: Woodworking question I would fill the teak with teak bungs, retained by marine epoxy like West. http://www.jamestowndistributors.com/userportal/show_product.do?pid=1940&familyName=Teak+Wood+Bungs+%2F+Plugs Keith Sneddon #4760, ?Are We There Yet?? From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, June 12, 2007 1:33 PM To: [email protected] Subject: catalina27-talk: Woodworking question Listmavins, I want to lead my halyards to the cockpit, but on my '73 model the handrails on the coach roof are right in the way. I need to move the handrails outboard, and want to reuse the old handrails, so my problem is drilling new holes that will either line up with existing screw holes in the rails, or plug the old holes and redrill (easiest I think). So here is the problem, what do you plug the holes in teak with, that will keep the wood strong, and won't force a drill bit off to the side when it hits it. Is fiberglass with milled fibers the way to go? Or teak dust and epoxy as a filler? Thanks in advance. Jim, "Tequila Chica" Dana Point, CA
