I am busy with Lab1B.
I am following the proctor guide, every command as per the guide. The results of the commands in the proctor guide compared to what I have running on the devices are very different. Is this an initial upload problem, is the guide not up to date? I have reverted the pod 2 times now and reloaded the initial config 3 times. 1 Example On page 51 of the proctor guide I am running: My result: Sw3(config-if)#do sh int trunk Port Mode Encapsulation Status Native vlan Fa0/5 on 802.1q trunking 1 Fa0/10 on 802.1q trunking 24 Fa0/23 on 802.1q trunking 1 Fa0/24 on 802.1q trunking 1 Port Vlans allowed on trunk Fa0/5 2,10 Fa0/10 1-4094 Fa0/23 1-4094 Fa0/24 1-4094 Port Vlans allowed and active in management domain Fa0/5 2 Fa0/10 1-2,24,99 Fa0/23 1-2,24,99 Fa0/24 1-2,24,99 Port Vlans in spanning tree forwarding state and not pruned Fa0/5 2 Port Vlans in spanning tree forwarding state and not pruned Fa0/10 1-2,24,99 Fa0/23 1-2,24,99 Fa0/24 none The above is different from what is on page 51. None of the tasks/verifications/ping commands in this lab has the same result as per the proctor guide. Can somebody from IPExpert assist?
