Did you load the initial configs? On Mon, Jun 8, 2009 at 7:53 AM, Johan Bornman <[email protected]> wrote:
> I am busy with Lab1B. > > > > I am following the *proctor guide*, every command as per the guide. The > results of the commands in the proctor guide compared to what I have running > on the devices are very different. Is this an initial upload problem, is the > guide not up to date? I have reverted the pod 2 times now and reloaded the > initial config 3 times. > > > > 1 Example > > On page 51 of the proctor guide I am running: > > *My result:* > > Sw3(config-if)#do sh int trunk > > > > Port Mode Encapsulation Status Native vlan > > Fa0/5 on 802.1q trunking 1 > > Fa0/10 on 802.1q trunking 24 > > Fa0/23 on 802.1q trunking 1 > > Fa0/24 on 802.1q trunking 1 > > > > Port Vlans allowed on trunk > > Fa0/5 2,10 > > Fa0/10 1-4094 > > Fa0/23 1-4094 > > Fa0/24 1-4094 > > > > Port Vlans allowed and active in management domain > > Fa0/5 2 > > Fa0/10 1-2,24,99 > > Fa0/23 1-2,24,99 > > Fa0/24 1-2,24,99 > > > > Port Vlans in spanning tree forwarding state and not pruned > > Fa0/5 2 > > > > Port Vlans in spanning tree forwarding state and not pruned > > Fa0/10 1-2,24,99 > > Fa0/23 1-2,24,99 > > Fa0/24 none > > > > The above is different from what is on page 51. > > > > None of the tasks/verifications/ping commands in this lab has the same > result as per the proctor guide. > > > > Can somebody from IPExpert assist? >
