Checked 1st router and I am on Version 12.4(13r)T 2nd Router Version 12.4(1r) [hqluong 1r]
3rd Router Version 12.4(1r) [hqluong 1r] How do I get the correct code if that is the problem? I don't think I have control over that. I was hoping that the initial uploads will be fine so that I can spend maximum time working through the labs. Having to check that the devices have uploaded correctly is very frustrating as I wouldn't know what is right and wrong. From: Stuart Hare [mailto:[email protected]] Sent: 08 June 2009 17:15 To: Brandon Carroll Cc: Johan Bornman; OSL Lab Exam Subject: Re: [OSL | CCIE_Security] Lab 1B The main issue with the load configs is the dual code versions on the routers so to provide r&s and sec support. Have u made sure your on 12.4 22 T code on the routers. My issues with initial configs have always been down to the wrong ios running. Even if you do use load cfgs always make sure the first thing u do is confirm l2 / l3 is all correct, all vlans exist ips are reachable etc. Sent from my iPhone On 8 Jun 2009, at 16:02, Brandon Carroll <[email protected]> wrote: Did you load the initial configs? On Mon, Jun 8, 2009 at 7:53 AM, Johan Bornman <[email protected]> wrote: I am busy with Lab1B. I am following the proctor guide, every command as per the guide. The results of the commands in the proctor guide compared to what I have running on the devices are very different. Is this an initial upload problem, is the guide not up to date? I have reverted the pod 2 times now and reloaded the initial config 3 times. 1 Example On page 51 of the proctor guide I am running: My result: Sw3(config-if)#do sh int trunk Port Mode Encapsulation Status Native vlan Fa0/5 on 802.1q trunking 1 Fa0/10 on 802.1q trunking 24 Fa0/23 on 802.1q trunking 1 Fa0/24 on 802.1q trunking 1 Port Vlans allowed on trunk Fa0/5 2,10 Fa0/10 1-4094 Fa0/23 1-4094 Fa0/24 1-4094 Port Vlans allowed and active in management domain Fa0/5 2 Fa0/10 1-2,24,99 Fa0/23 1-2,24,99 Fa0/24 1-2,24,99 Port Vlans in spanning tree forwarding state and not pruned Fa0/5 2 Port Vlans in spanning tree forwarding state and not pruned Fa0/10 1-2,24,99 Fa0/23 1-2,24,99 Fa0/24 none The above is different from what is on page 51. None of the tasks/verifications/ping commands in this lab has the same result as per the proctor guide. Can somebody from IPExpert assist?
