Do a dir flash on the device usually on proctorlabs there are are 2
code versions 12.4 22 T and 12.4 3T.
Check your config register to ensure it's set correctly the issue the
boot system flash <image filename> and then reload the device.
As rack 1 is shared between the r&s and security pods it's pot luck
with who used it last I suppose.
Generally it's worth a quick check prior to loading the cfgs.
Stu
Sent from my iPhone
On 8 Jun 2009, at 17:02, "Johan Bornman" <[email protected]> wrote:
Checked 1st router and I am on Version 12.4(13r)T
2nd Router Version 12.4(1r) [hqluong 1r]
3rd Router Version 12.4(1r) [hqluong 1r]
How do I get the correct code if that is the problem? I don’t think
I have control over that.
I was hoping that the initial uploads will be fine so that I can
spend maximum time working through the labs.
Having to check that the devices have uploaded correctly is very
frustrating as I wouldn’t know what is right and wrong.
From: Stuart Hare [mailto:[email protected]]
Sent: 08 June 2009 17:15
To: Brandon Carroll
Cc: Johan Bornman; OSL Lab Exam
Subject: Re: [OSL | CCIE_Security] Lab 1B
The main issue with the load configs is the dual code versions on
the routers so to provide r&s and sec support. Have u made sure your
on 12.4 22 T code on the routers.
My issues with initial configs have always been down to the wrong
ios running.
Even if you do use load cfgs always make sure the first thing u do
is confirm l2 / l3 is all correct, all vlans exist ips are reachable
etc.
Sent from my iPhone
On 8 Jun 2009, at 16:02, Brandon Carroll
<[email protected]> wrote:
Did you load the initial configs?
On Mon, Jun 8, 2009 at 7:53 AM, Johan Bornman <[email protected]> wrote:
I am busy with Lab1B.
I am following the proctor guide, every command as per the guide.
The results of the commands in the proctor guide compared to what I
have running on the devices are very different. Is this an initial
upload problem, is the guide not up to date? I have reverted the pod
2 times now and reloaded the initial config 3 times.
1 Example
On page 51 of the proctor guide I am running:
My result:
Sw3(config-if)#do sh int trunk
Port Mode Encapsulation Status Native vlan
Fa0/5 on 802.1q trunking 1
Fa0/10 on 802.1q trunking 24
Fa0/23 on 802.1q trunking 1
Fa0/24 on 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/5 2,10
Fa0/10 1-4094
Fa0/23 1-4094
Fa0/24 1-4094
Port Vlans allowed and active in management domain
Fa0/5 2
Fa0/10 1-2,24,99
Fa0/23 1-2,24,99
Fa0/24 1-2,24,99
Port Vlans in spanning tree forwarding state and not pruned
Fa0/5 2
Port Vlans in spanning tree forwarding state and not pruned
Fa0/10 1-2,24,99
Fa0/23 1-2,24,99
Fa0/24 none
The above is different from what is on page 51.
None of the tasks/verifications/ping commands in this lab has the
same result as per the proctor guide.
Can somebody from IPExpert assist?
