When adding CAS circuit in CCM (MGCP) it gives option to enable channels for 
Outbound/Inbound/Bothways. I never tried but won't that work for us.

Secondly, if CAS circuit in H.323 mode you may create multiple DS0 and point 
DPs to respective voice-ports for outbound calls leaving others for inbound.



Paul and Bobs <[EMAIL PROTECTED]> wrote: Thanks for the reply. How can this 
this be achieved. I know from the PABX world , you can control the number of 
outbound and inbound channels and would love to find a way of doing this i the 
Cisco world on either MGCP or H.323. Doesnt matter which one (both would be 
good) but if not then just one of them.
 
Cheers

On Wed, Oct 29, 2008 at 11:02 PM, Mark Snow <[EMAIL PROTECTED]> wrote:
 No because you can't create two pri-group timeslot service mgcp commands 
because then you would have to create two mgcp gateways in CUCM and 4.1.3 won't 
allow you to do this to the same hostname. 
 
Mark SnowSr Technical Instructor
IPexpert, Inc.

Sent from my iPhone




On Oct 28, 2008, at 11:36 PM, "Paul and Bobs" <[EMAIL PROTECTED]> wrote:
 


Thanks Mark

If I wanted to just use mgcp, is there a way to control which channels are 
used. So I can reserve 10 channeles for outgoing and 10 for incoming with a 
total of 20
 
On Wed, Oct 29, 2008 at 2:19 PM, Mark Snow <[EMAIL PROTECTED]> wrote:
  BTW - that's not to say that I recommend it - but for lab purposes should be 
all good.  There could be bugs associated with it - and I would definitely 
check BugNavigator before putting it into production :)


cheers,
     
-- 
Mark Snow
CCIE #14073 (Voice, Security)


Senior Technical Instructor - IPexpert, Inc.


Telephone: +1.810.326.1444
Fax: +1.309.413.4097
  Mailto: [EMAIL PROTECTED]
--
Join our free online support and peer group communities: 
http://www.IPexpert.com/communities
  --
IPexpert - The Global Leader in Self-Study, Classroom-Based, Video-On-Demand 
and Audio Certification Training Tools for the Cisco CCIE R&S Lab, CCIE 
Security Lab, CCIE Service Provider Lab , CCIE Voice Lab and CCIE Storage Lab 
Certifications.
  --

 


On Oct 28, 2008, at 10:20 PM, Paul and Bobs wrote:



Hi All

I was wandering if anyone know of a way using both MGCP and H.323 to control 
the channells on an E1/T1 circuit. For example - If I have a single E1 service 
with only 20 channels and I want to say reserve 5 for outgoing and reserve 15 
for incoming, is there a way on both protocols to do this.
   
Thanks

Paul








 





 

       

Reply via email to