Replies to this message are sent to The Chevelle Mailing List
------------------------------------------------------------
fred
If chevelles follow camaros, and I bet that they do , the x-members
are different. I have a 400 specific x-member on order for my 68
camaro. It is different than the original.
rick
On Wed, 29 Aug 2001 19:04:44 -0400 "Fred Knoche" <[EMAIL PROTECTED]>
writes:
>
>Replies to this message are sent to The Chevelle Mailing List
>------------------------------------------------------------
>
>When I bought my 67, the guy had replaced the PG with a TH 350. I went
>to
>put my new TH 400 in today, and I have run into a problem I need some
>help
>on. There isn't enough room between the crossmember mounting surface
>and the
>mounting surface on the trans. to fit the trans. mount. I need about
>another
>3/4 inch. The mount is a duplicate of the old one from a local trans
>supply
>house. If I jack the engine/trans higher it hits the shifter linkage
>where
>it comes out the floor. Are 350 crossmembers different than 400's? My
>only
>solution is to remove and reweld the crossmember mounting surface
>lower on
>the crossmember. Any ideas, suggestions would help.
>Thanks
>Fred
>
>
>-----------------------------------------------------
>To Unsubscribe please visit www.chevelles.net/list.html
>To start a new topic, send mail to: [EMAIL PROTECTED]
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]
