Ok i am lost again.  I have determined that i have the distributor installed 
right but i am just not getting fire.  I have replaced the Accel super coil 
and put in a Accel Billet distributor and it already had Accel plug wires so 
i left them.  I dont know what is wrong i pulled a spark plug a layed it on 
the header and the plug never arced.  What am i doing wrong.
Thanks
Michael


>From: [EMAIL PROTECTED]
>Reply-To: [EMAIL PROTECTED]
>To: [EMAIL PROTECTED]
>Subject: Re: [Chevelle-List] NEED HELP
>Date: Sat, 4 May 2002 23:22:53 EDT
>
>This is from an engine install instruction.........
>
>Install dist. Remove the #1 spark plug and plug the hole with your finger.
>Slowly turn the engine over (clockwise) until pressure is felt. Remove your
>finger and continue slowly turning the engine until you reach the timing 
>mark
>you want for initial timing at idle (usually 10-12 degrees btdc). You can
>double check this by watching the valves (driver side valve cover off,  #1
>intake should open then close) Line this mark up with your pointer and drop
>the dist. in. Line the rotor up with the #1 wire on the dist. cap. You may
>have to turn the oil pump shaft with your primer or a long screwdriver to 
>get
>the dist. to drop in where you want it. A tip is to use a paint stick; drop
>it onto the oil pump shaft and turn it towards cylinder #7 (last cylinder 
>on
>driver's side next to the firewall). This should let the dist. drop in with
>the rotor facing the front of the motor and cylinder #1 on the cap. (About 
>6
>o'clock position but on #1 wire) Once the dist. is in and seated down 
>fully,
>snug down the clamp. The timing marks should be on 10-12 degrees btdc and 
>the
>rotor facing #1 wire on the cap. Double-check the firing order of the wires
>on your cap. It should be 1-8-4-3-6-5-7-2 in a clockwise pattern around the
>cap looking from the top. This will be surprising close and the engine 
>should
>fire.
>
>-----------------------------------------------------
>To Unsubscribe please visit www.chevelles.net/list.html
>To start a new topic, send mail to: [EMAIL PROTECTED]




_________________________________________________________________
Chat with friends online, try MSN Messenger: http://messenger.msn.com


-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]

Reply via email to