I guess I should have mentioned my rear gears are 3.55. First gear is real low and I can only imagine what a 4.10 would be like. In the quarter I'm spinning my 285/40s most of the way through second. ----- Original Message ----- From: "Clint Hooper" <[EMAIL PROTECTED]> To: "The Chevelle Mailing List" <[email protected]> Sent: Wednesday, February 02, 2005 7:19 PM Subject: Re: [Chevelle-list] th700R4
> I used a similar set-up like Mike's behind the 468" in my 68 El Camino. 3rd > gear would lock & unlock while 4th was always locked-up. After four years of > hard street use,the stock converter lock-up clutch started to slip under > full throttle so I replaced the converter with a custom Vigilante 2,600rpm > lock-up converter. End of problems. With a healthy 468" and 4.10 cogs in > back,that car would practically smoke the 275/35/20 Michelin Pilots at will > under 60mph. If I were doing it again,however,I would run a built 200R4 > instead with some 3.55 cogs. A 700R4 and 4.10's make for an overgeared > combination,IMO. > Clint Hooper > H&H Custom,owner > 1969 El Camino ProTourer > http://dalesplace.com/misc/friends/clint/clint_hooper.htm > 2001 H-D FLHR custom bagger > ----- Original Message ----- > From: "Mike Holleman" <[EMAIL PROTECTED]> > > > > Wayne, I have a 700R4 behind a built 421 tripower in my 64 Tempest. I am > > using a lockup converter w/manual switch because it was highly recommended > > by Bowtie Overdrives, which is where the trans came from. Their reasoning > > was because of heat created by converter slippage in overdrive. My > converter > > only locks in overdrive and I do see a substantial difference in trans > temp > > when I drive alot in third versus in OD. BTO says the trans temp should > not > > be much above 150 for extended periods. The only time I see higher temps > is > > on hot days when I am not getting into OD/lockup mode. Hope this helps. > > Mike Holleman > > > > > > ----- Original Message ----- > > From: "Wayne" <[EMAIL PROTECTED]> > > To: "The Chevelle Mailing List" <[email protected]> > > Sent: Wednesday, February 02, 2005 1:01 PM > > Subject: [Chevelle-list] th700R4 > > > > > > > I am gathering parts from my up coming street rod Project. 38 chevy > coupe. > > I > > > have a 700 R4 in my 65 Elky and like it . > > > I stoped at the local HP trans builder. and we talked about what I > > > wanted...He suggested a 89 later with all the transgo stuff HD sun > shell > > > 39 sprag and 13 vane pump.. ect But also said " In his opnion" He > would > > > prefer I use a NONE lock up converter with the none lock up valve and > > none > > > lock up converter... > > > 2000-2300 RPM none lock up converter and modified to run full fluid/oil > > > flow in 4th gear. > > > This will go behind a ZZ4 350 with the LT1 hot Cam (395 HP and 425 ftlb > > > tourque) 9" ford .370 rear and 3300 LB aprox. > > > > > > Any feedback on the None lockup VS Lock up ? > > > > > > Wayne > > > ACES 1556 > > > TC 186 > > > > > > Ps I use the TCI scheme lock up with a vacumn switch on the elky.. > > > > > > > > > > > > > > > >
