Thanks for the suggestion, I cleaned the prongs with alcohol I'll clean the base and try again.
> On August 22, 2020 at 3:50 PM Jim Unroe < [email protected] > mailto:[email protected] > wrote: > > > On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke < [email protected] > mailto:[email protected] > wrote: > > > > > > On Wednesday my 2 BaoFeng UV 5R radios could download and upload > to CHIRP. > > > > > > > > On Friday all I got was the following message: Radio Did Not > Respond. > > > > > > > > I tried reloading the latest version of CHIRP, no change. I tried > an earlier version of CHIRP, no change. I reloaded the latest version back, > no change. Visually the radio's red light blinks then the LED display blinks > then the error message shows up on CHIRP. > > > > > > > > > > Any suggestions? > > > > > > > > Thanks Chuck KJ7INT > > > > > Hi Chuck, > > You will get the exact same error message if you don't plug the 2-pin > plug into the radio. So make sure that the 2-pin plug is fully > inserted into the socket of the radio. Some have had to put a little > pressure on the plug during the cloning process. > > Jim KC9HI > _______________________________________________ > chirp_users mailing list > [email protected] > mailto:[email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Chuck at [email protected] mailto:[email protected] > To unsubscribe, send an email to > [email protected] > mailto:[email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
