no luck yet. I tried pressure straight into the radio, to the back side of the radio, to the front side of the radio, to the top of the radio and to the bottom of the radio. similar results, the LCD screen blinks and goes back to the beginning screen.
thanks again for the suggestion > On August 22, 2020 at 3:50 PM Jim Unroe < [email protected] > mailto:[email protected] > wrote: > > > On Sat, Aug 22, 2020 at 6:46 PM Charles Gierke < [email protected] > mailto:[email protected] > wrote: > > > > > > On Wednesday my 2 BaoFeng UV 5R radios could download and upload > to CHIRP. > > > > > > > > On Friday all I got was the following message: Radio Did Not > Respond. > > > > > > > > I tried reloading the latest version of CHIRP, no change. I tried > an earlier version of CHIRP, no change. I reloaded the latest version back, > no change. Visually the radio's red light blinks then the LED display blinks > then the error message shows up on CHIRP. > > > > > > > > > > Any suggestions? > > > > > > > > Thanks Chuck KJ7INT > > > > > Hi Chuck, > > You will get the exact same error message if you don't plug the 2-pin > plug into the radio. So make sure that the 2-pin plug is fully > inserted into the socket of the radio. Some have had to put a little > pressure on the plug during the cloning process. > > Jim KC9HI > _______________________________________________ > chirp_users mailing list > [email protected] > mailto:[email protected] > http://intrepid.danplanet.com/mailman/listinfo/chirp_users > This message was sent to Chuck at [email protected] mailto:[email protected] > To unsubscribe, send an email to > [email protected] > mailto:[email protected] >
_______________________________________________ chirp_users mailing list [email protected] http://intrepid.danplanet.com/mailman/listinfo/chirp_users This message was sent to [email protected] at [email protected] To unsubscribe, send an email to [email protected]
