Steve, As far as I can tell, I'm not receiving an IP address. Yes, I'm performing reachability tests directly from the router.
========== SH IP ROUTE ========== S* 0.0.0.0/0 is directly connected, Dialer1 C x.x.x.x/22 is directly connected, FastEthernet0/0 Plus: rr2#sh atm int atm0/0/0 Interface ATM0/0/0: AAL enabled: AAL5 AAL2, Maximum VCs: 23, Current VCCs: 1 VCIs per VPI: 256, Max. Datagram Size: 4528 PLIM Type: ADSL - 832Kbps Upstream, DMT, TX clocking: LINE 0 input, 67960 output, 0 IN fast, 0 OUT fast Avail bw = 832 Config. is ACTIVE rr2#sh atm traffi Input OAM Queue: 0/64 (size/max) 0 Input packets 67965 Output packets 0 Broadcast packets 0 Packets received on non-existent VC 0 Packets attempted to send on non-existent VC 0 OAM cells received F5 InEndloop: 0, F5 InSegloop: 0, F5 InAIS: 0, F5 InRDI: 0 F5 InEndcc: 0, F5 InSegcc: 0, F4 InEndloop: 0, F4 InSegloop: 0, F4 InAIS: 0, F4 InRDI: 0 0 OAM cells sent F5 OutEndloop: 0, F5 OutSegloop: 0, F5 OutRDI: 0 F5 OutEndcc: 0, F5 OutSegcc: 0, F4 OutEndloop: 0, F4 OutSegloop: 0, F4 OutRDI: 0 0 OAM cell drops Thanks, Adam ----- Original Message ----- From: "Steve Bertrand" <[EMAIL PROTECTED]> To: "Adam Greene" <[EMAIL PROTECTED]> Cc: <[email protected]> Sent: Tuesday, October 02, 2007 2:09 PM Subject: Re: [c-nsp] PPPoA DSL up/up, no traffic > Adam Greene wrote: >> Hi, >> >> I'm trying to configure a DSL line on a Cisco 1841 (C1841-IPBASE-M), >> Version >> 12.4(1c). >> >> The atm interface is plugged into a DSL line, it shows up/up, I have >> packets >> going out, but none coming back in. > > What is the IP address on the ATM interface after negotiation? > > What does: > > sh ip route > > ...tell you? > > Are you performing your Internet reachability tests directly from your > router? > > Steve > > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
