> Hey Guys, > > ... Assuming that VLAN 100 is to be your native VLAN:
* Remove interface BVI1 * Remove "bridge-group 1 route ip" * Add "bridge-group 100 route ip" * Add interface BVI100 and assign IP BVI1 is linked to bridge-group 1. Typically, Fa0 would be bridged to group 1, but since you are not bridging Fa0 to anything, you need to enable management access via a different VLAN. Using the example above, for bridge-group 100 you will need an interface by the name of BVI100 to associate it with bridge-group 100, and thus Fa0.100. You can then assign an IP address as per the VLAN 100 subnet, and this should allow you IP management access. Thats a simple explanation, hopefully it made sense (was a quickie). _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
