Tom, Try this:
version 12.3 no service pad service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname ap ! enable secret 5 $1$/zGH$xzsRGAXFpaqMQdyblohgC. ! ip subnet-zero aaa new-model please let us know, Anna -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Joel Perez Sent: Tuesday, December 18, 2007 2:02 PM To: Tom Storey Cc: [email protected] Subject: Re: [c-nsp] AP-1242AG config Ok, tried removing BVI1 and replace it with another BVI but it isnt allowed to remove it. Also couldnt do "bridge-group 100 route ip" This command is only allowed on bridge-group 1. I ended up having to change the native vlan on the switch trunk port to match the IP I wanted to use for BVI1. It seems that cisco doesnt let you change BVI1 to match any other vlan unless you make that vlan the native vlan. For now I can reach the AP to manage it, so its a hack/workaround but unless im missing something else im stuck with only being able to use the native vlan as a management interface. Thanks for the help guys, Joel P On 12/17/07, Tom Storey <[EMAIL PROTECTED]> wrote: > > > Hey Tom, > > > > > > Makes perfect sense. I tried using BVI100 but didn't add > > bridge-group 100 route IP. > > > > That should work exactly the way I need it. Thanks for explanation. > > > > Joel P. > > > > -----Original Message----- > > From: Tom Storey [mailto:[EMAIL PROTECTED] > > Sent: Monday, December 17, 2007 7:49 PM > > To: Joel P > > Cc: [email protected] > > Subject: Re: [c-nsp] AP-1242AG config > > > >> Hey Guys, > >> > >> ... > > > > Assuming that VLAN 100 is to be your native VLAN: > > > > * Remove interface BVI1 > > * Remove "bridge-group 1 route ip" > > * Add "bridge-group 100 route ip" > > * Add interface BVI100 and assign IP > > > > BVI1 is linked to bridge-group 1. Typically, Fa0 would be bridged to > group > > 1, but since you are not bridging Fa0 to anything, you need to enable > > management access via a different VLAN. Using the example above, for > > bridge-group 100 you will need an interface by the name of BVI100 to > > associate it with bridge-group 100, and thus Fa0.100. You can then > assign > > an IP address as per the VLAN 100 subnet, and this should allow you IP > > management access. > > > > Thats a simple explanation, hopefully it made sense (was a quickie). > > > > > > No problems. > > If youre still stuck, I can forward you a copy of my 1242AG config. Ive > got a management address on BVI1 which is bridged to Fa0 which sits in > VLAN 1, my native VLAN, but it looks as though it might just be that you > are missing the right combination of commands related to the BVI and > bridge-group. > > Make sure to mail the list if you get it sorted :-) > > Cheers. > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
