Hi! Thanks for your reply.
I have just simple MPLS and BGP config too. #sh run | in mpls mpls ldp loop-detection mpls label protocol ldp mpls mtu 1540 mpls ip mpls mtu 1540 mpls ip mpls mtu 1540 mpls ip mpls ldp router-id Loopback0 force #sh mpls interfaces Interface IP Tunnel BGP Static Operational Vlan100 Yes (ldp) No No No Yes Vlan410 Yes (ldp) No No No Yes Vlan301 Yes (ldp) No No No Yes > hi pavel, > > i must admit, i'm not an mpls guru, but im working on it ;) whilst i > can't offer you any direct solution, i can say i'm a bit fascinated by > this because i have for example a sup720 3bxl taking 3 x full views 243k > routes per peer, have mpls tag switching enabled on 5 SVI's and i dont see > the behaviour you see. > > router#sh mpls int | i Vl Vlan2 Yes (ldp) No > Yes > Vlan3 Yes (ldp) No Yes > Vlan4 Yes (ldp) No Yes > Vlan12 Yes (ldp) No Yes > Vlan14 Yes (ldp) No Yes > > > router# sh ip bgp sum Neighbor V AS MsgRcvd MsgSent TblVer > InQ OutQ Up/Down > State/PfxRcd > 61.88.xxx.xx 4 7474 19165667 424902 69092680 0 0 21w2d > 243009 > 61.88.xxx.xx 4 7474 20943846 426386 69092680 0 0 5w2d > 243007 > 220.157.xx.x 4 9723 12753587 15032863 69092733 0 0 2w0d > 243093 > > > router#sh platform hardware cap | b L3 Forward L3 Forwarding Resources > FIB TCAM usage: Total Used > %Used > 72 bits (IPv4, MPLS, EoM) 524288 246423 > 47% > 144 bits (IP mcast, IPv6) 262144 5 > 1% > > > router#sh mpls ip bind sum Total number of prefixes: 1453 > > > Generic label bindings > assigned learned prefixes in labels out labels 1453 > 1446 13042 > > > my mpls config is pretty straight forward > > mpls label range 16 256000 mpls label protocol ldp no tag-switching ip > propagate-ttl tag-switching tdp router-id Loopback0 force > > ... very curious !! > > > hardware is sup720 pfc3bxl with ios 12.2(18)SXF8 > > kind regards, > > --matt > > > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
