They won't work in those slots.
Tim
At 04:54 PM 8/28/2008, Eric Cables observed:
I am in a situation where we have 4x 6513s and an assortment of
6700/6500 series blades. I know that the 6513 has limitations on
which modules have dual channel fabric connections (9-13), but I am
not 100% sure how the 6700 series blades will act in the other slots.
I have been told by our Cisco SE that the 6748 blade will not function
in blades 1-8, but I wanted to confirm whether that was true. The
reason I suspect that it will is because we have some 6724 modules in
slot #1 that are operating at 1x20Gbps.
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ -----------
------- -------
1 Centralized Forwarding Card WS-F6700-CFC [removed] 2.0 Ok
SDHQ-CS-02-01#show fabric utilization
slot channel speed Ingress % Egress %
1 0 20G 0 0
System Resources
PFC operating mode: PFC3BXL
Supervisor redundancy mode: administratively sso, operationally sso
Switching resources: Module Part
number Series CEF mode
1 WS-X6724-SFP CEF720
CEF
My question is this: Will a 6748 act the same way, with a single
1x20Gbps connection to the fabric, or will it not work at all?
Thanks,
--
Eric Cables
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
Tim Stevenson, [EMAIL PROTECTED]
Routing & Switching CCIE #5561
Technical Marketing Engineer, Data Center BU
Cisco Systems, http://www.cisco.com
IP Phone: 408-526-6759
********************************************************
The contents of this message may be *Cisco Confidential*
and are intended for the specified recipients only.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
