Hi, i am using cisco 6509 with two sup engines. sup1 is main and sup2 is standby. The problem is sup2 is not booting automatically when the system is switched ON. it is going to rommon mode, where we have to type boot command so that it will boot. after booting, boot variable is missing. if we set the boot variable,it will show the boot variable but it is temporary.
Again we switched OFF and ON, The same situation is there. i tried lot, please help me. some details are here... Before sup2: CAT_1> (enable) sh mod Mod Slot Ports Module-Type Model Sub Status --- ---- ----- ------------------------- ------------------- --- ----- --- 1 1 2 1000BaseX Supervisor WS-X6K-S2U-MSFC2 yes ok 15 1 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok 3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok 9 9 8 1000BaseX Ethernet WS-X6408A-GBIC no ok After sup2: CAT_1> (enable) sh mod Mod Slot Ports Module-Type Model Sub Status --- ---- ----- ------------------------- ------------------- --- ----- --- 1 1 2 1000BaseX Supervisor WS-X6K-S2U-MSFC2 yes ok 15 1 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok 2 2 2 1000BaseX Supervisor WS-X6K-S2U-MSFC2 yes standby 16 2 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok 3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok 9 9 8 1000BaseX Ethernet WS-X6408A-GBIC no ok bye. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
