Peter Chuba wrote:
Hi,
I've got a 2801 whose built-in ports are damaged. I was wondering if I could
add an HWIC-4ESW module and use this to connect to both the provider and
LAN. And will I be able to do NAT with this setup? Will I also be able to do
PPPOE on the vlan interface? I think it should work but want to be sure
before buying the card.
They are switch ports, not routed ports, but you can use SVI with them
for routing. Never tried PPPoE. Have done NAT, works fine. Think of it
like putting a switch into your router rather than adding router ports.
You might have to go with an HWIC-1FE for PPPoE.
~Seth
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
