Mark Tech <> wrote on Thursday, April 09, 2009 13:15:
> Hi
> I would like to cap a physical GE interface to 100mbps whist running
> vlans through it on a GSR i.e.
>
[...]
>
> However when I apply the rate-limit command on GE0/0/6, I don't see
> any drop in traffic. Actually I have set up a throughput test through
> GigabitEthernet0/0/6.2 running at 1Gbps which I can see through sh
> int GigabitEthernet0/0/6 which does not drop to 100Mbps once the
> rate-limit is added
>
> Is there a way to cap this aggregate interface?
On Engine3/5 linecards, you can use
policy-map gig-out
class class-default
police 1000000000
!
int gig0/0/6
service-policy output gig-out
!
int gig0/0/6.<vlan>
...
You can also use "match vlan" classes to provide differentiated treatment for
vlans..
oli
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
